11kV Pin Type Composite Insulators specification in Kenya has been prepared by the Research and Development Department of KPLC and the Design & Operations Departments of REA. It lays down requirements for 11 & 33kV Pin Type Composite Insulators. It is intended for use by KPLC/REA in purchasing the insulators.

11kV Pin Type Composite Insulators

It shall be the responsibility of the manufacturer to ensure adequacy of the design and good engineering practice in the manufacture of the insulators for KPLC/REA. The manufacturer shall submit information which confirms satisfactory service

The references of 11kV Pin Type Composite Insulators
The following documents were referred to during the preparation of this specification; in case of conflict, the requirements of this specification shall take precedence.
◆ IEC 120: Dimensions of ball and socket couplings of string insulator units
◆ IEC 815: Guide for the selection of insulators in respect of polluted conditions
◆ ISO 1461: Metallic Coatings – Hot dip galvanized coatings on fabricated ferrous products – Requirements
◆ ISO 1460: Metallic Coatings – Hot dip galvanized coatings on fabricated ferrous metals – Determination of mass per unit area – Gravimetric method
◆ IEC 1109: Composite insulators for a.c. overhead lines with a nominal voltage greater than 1000V – Definitions, test methods and acceptance criteria.

If you want to buy 11kV Pin Type Composite Insulators or 33kV composite pin type insulators, please contact Orient Power.

Relative Articles:
IEC BS 900mm creepage distance porcelain pin insulator
Composite polymer pin insulators medium voltage
Porcelain grey glazed pin insulator